Bag D - Team Losi XXX-NT Adam Drake Edition Owner's Manual

Figure 51
!
Step 1. Attach the dogbones (107) to the plastic universal
yokes (106) by lining up the slot on the dogbone (107) with the
groove in the universal yoke (106). Secure the two pieces with a
!
4-40 x 3/8" cap-head screw (17).
A small amount of thread-lock compound should be
used on the threads of the 4-40 x 3/8" screws to help keep them
tight.
Figure 52
108
!
Step 2. Position the universal pivot (108) in the rear axle
(109) so that the holes in both are aligned.
!
Step 3. Using pliers, carefully push a 3/32" x 1/2" spirol pin
(110) through the rear axle (109) and universal pivot (108) until
!
the pin (110) extends evenly from both sides of the rear axle (109).
The pin can be made to press in tighter. This will en-
sure that it stays firmly in place. To do so, SLIGHTLY crimp the
center of the pin with heavy duty wire cutters. When inserting the
pin, be careful not to smash the ends of the pin, or the universal
may not operate freely.
*NOTE: Some kits may include factory assembled axles.
Figure 53
!
Step 4. Using the small end of the assembly wrench (111)
supplied with your kit, pry the pins on the universal pivot (108)
!
into the holes in the plastic universal yoke (106).
The dogbones should rotate freely. If they do not,
the ears of the universal yoke can be squeezed slightly with a pair
of pliers. Squeezing the ears will press the outside of the hole in
the ears against the pin in the universal pivot. This will cause the
hole to enlarge slightly, helping the dogbone to rotate freely.

BAG D

17
110
17
109
Figure 53
2 2
106
107
Figure 51
110
Figure 52
108
106
108
111