Team Losi XXX-NT Adam Drake Edition Owner's Manual page 51

RADIO INSTALLATION
Figure 110
!
Step 35. Snap the 4mm ball cup (204) onto the ball on the
carburetor. Make sure the ball is pointing toward the right side of
the truck and slightly upward.
!
Step 36. Press the throttle servo horn (190) and throttle servo
spline insert (200) onto the output shaft of the servo, and secure it
with the screw included with your servo. Be sure the servo output
shaft is centered and the servo horn is aligned properly, as shown.
!
Step 37. Insert the end of the brake lever (102) through the
hole in the over-ride slider (195) on the brake likage.
!
Step 38. Place a linkage collar (192) over the end of the brake
lever (102) and secure it with w 4-40 x 1/8" set screw (193).
*NOTE: The slider should fit loosely under the linkage col-
lar to prevent binding.
Figure 111
!
Step 39. Attach one end of the throttle return spring (202) to
the hole in the eyelet (199). Attach the other end of the spring
(190) to the hole toward the edge of the servo arm as shown.
!
Step 40. Remove the air filter (165) from the air filter boot
(166). Check to see that the throttle return spring is holding the
carburetor closed, and that the linkage is not pulling the carbure-
tor open.
!
Step 41. Looking through the air filter boot (166) into the
carburetor, check the opening of the small, half-moon area near
the side. This opening should be approximately 1/32" (1mm) in
the fully closed position. If it is not, refer to your engine instruc-
tions and adjust the idle adjustment screw until the opening is
1/32" (1mm) with the throttle closed.
Slide Valve Carburetors
193
192
193
102
195
190
190
48
(Continued)
Figure 110
202
199
Figure 111
204