Team Losi XXX-NT Adam Drake Edition Owner's Manual page 31

Figure 64
!
Step 6. Using needle nose pliers, or small vise grips, grasp
the front shock shaft (130) between the grooves and thread a shock
end (133) onto the shaft (130). Thread the shock end (133) all the
way onto the shaft (130).
!
Step 7. Repeat Step 6 for the second front shaft (130) and both
rear shafts (131).
!
Step 8. Carefully snap a 1/4" swivel ball (134) into the two
shock ends (133) on the shorter, front shock shafts (130) only.
IMPORTANT NOTE: Do not insert 1/4" balls into the
rear shock ends (attached to the longer shock shafts). These balls
are already attached to the rear suspension arms.
Figure 65
!
Step 9. Snap a 1/8" E-clip (46) into the groove closest to the
cartridge on both rear (long) shock shafts (131).
!
Step 10. Before installing the E-clip to the front shock shafts
(130) - the shorter of the two lengths - slide a plastic spacer marked
with a small "A" (120) over the front shaft (130) next to the cartridge.
Once the spacers are in place, snap a 1/8" E-clip (46) into the groove
closest to the cartridge on both front shock shafts (130).
*NOTE: Shock spacers are only used on the front shock shafts
in this step.
!
Step 11. Slide a #55 (orange) shock piston (135) onto each of
the front shafts (130) until it rests against the E-clip (46). Secure
the pistons (135) to the front shafts (130) with a second E-clip
(46).
*NOTE: The orange #55 shock pistons are used on the front
(short) shock shafts. The red #56 shock pistons are used on the
rear (long) shock shafts.
!
Step 12. Slide a #56 (red) shock piston (136) onto each of the
rear shafts (131) until it rests against the E-clip (46). Secure the
pistons (136) to the rear shafts (131) with a second E-clip (46).
BAG E (Continued)
134
46
133
134
130
130
120
46
2 8
Figure 64
135
Figure 65
131
131
136