Team Losi XXX-NT Adam Drake Edition Owner's Manual page 12

Figure 19
7
!
Step 13. Insert a 3/8" ball stud (38) into the middle hole on
top of each spindle carrier (42), (43) from the front as shown, and
tighten.
IMPORTANT NOTE: Do not overtighten the ball studs!
!
Step 14 . Insert a 4-40 mini locknut (7) into the hex area in the top
of each spindle (40), (41). Place a ball stud washer (9) over a 1/4" ball
stud and thread it into the nut from the bottom of the spindle (40), (41)
and tighten.
Figure 20
46 50
!
Step 15. Attach the right spindle and carrier assembly to a
front suspension arm (48) as shown in Figure 20. Note that the
spindle arm faces the side of the suspension arm (48) with the
shock mount holes (rear) and the ball stud pointing forward. Line
up the holes in the spindle carrier (42) with the holes in the front
arm (48), insert a 1/8" x .960" hinge pin (50) and attach a
1/8" E-clip (46) to both sides of the hinge pin (50).
!
Step 16. Attach the arm (48) to the right side of the front
pivot block (49) by inserting a 1/8" x 1.42" hinge pin (51), from
the front, through the arm (48) and pivot block (49) as shown in
Figure 20.
!
Step 17. Insert a 1/8" E-clip (46) in the groove in the rear of
the hinge pin (51) only.
!
Step 18. Repeat Steps 15-17 for the left spindle and carrier
assembly and remaining front suspension arm (48).
!
Step 19. Slide the front hinge pin brace (52) over the front of
both inner hinge pins (51). The E-clip grooves in both hinge pins
(51) should be exposed in front of the brace (52). Secure the brace
(52) by attaching a 1/8" E-clip (46) to the front of each hinge pin
(51).
BAG B (Continued)
10
38
51
9
7
9
10
48
42
50
9
38
42
Figure 19
49
51
46
Figure 20
52
46