Team Losi XXX-NT Adam Drake Edition Owner's Manual page 40

ENGINE INSTALLATION
Figure 84
!
Step 27. Place the silicone exhaust coupler (174) over the end of
the exhaust header (171) as shown.
!
Step 28. Insert the tuned pipe (175) into the opposite end of
the exhaust coupler (174) so that the exit pipe in the side of the pipe
(175) points away from the truck, and the mounting stud points straight
up.
Figure 85 & Continue on Step 34/Fig. 87
17
!
Step 29 . Insert the straight end of the pipe mount "L" wire (177)
into the unthreaded hole in the mounting stud on the tuned pipe (175)
so that the bend and end with the mounting loop are behind the stud.
Thread a 5-40 set screw (47) into the threaded hole at the top of the
mounting stud of the pipe (175) but do not tighten completely.
!
Step 30. Place a #4 washer (23) over a 4-40 x 3/8" cap-head screw
(17). Position the loop of the mounting wire over the hole just forward
of the fuel tank in the center brace. Place the 4-40 screw/washer
through the loop in the end of the mounting wire and thread it until
tight as shown in Figure 85. Tighten the 5-40 set screw (47) in the top
of the mounting stud on the pipe (175).
Figure 87
!
Step 34. Secure the tuned pipe (175) to the coupler (174) by wrap-
ping an 8" tie strap (180) around the coupler (174), and the pipe (175),
and tightening.
!
Step 35. Secure the coupler (174) to the header (171) by wrap-
ping an 8" tie strap (180) around the coupler (174) and header
(171) and tightening. Cut off the extra length from both tie straps
(180).
23
175
174
Figure 84
Figure 85
175
180
3 7
(Continued)
171
17
23
174
171
Figure 87
177
47
175
29