Team Losi XXX-NT Adam Drake Edition Owner's Manual page 45

RADIO INSTALLATION
Figure 96
!
Step 17. Remove the two small screws from the switch (sup-
plied with radio system). Place the switch, from the bottom, into
the switch mount (189).
!
Step 18. Place the switch top plate (if applicable) over the
switch, on top of the switch mount (189). Line up the holes in the
switch with the holes in the top plate and secure the switch to the
switch mount (189) with the two screws from the switch.
!
Step 19. Plug the switch lead into the slot marked "Battery"
!
in the receiver.
Some racers prefer to eliminate the switch and replace
it with a servo extension wire. If you wish to replace the switch
with an extension wire, plug one end of the wire into the slot
marked "Battery" in the receiver.
!
Step 20. Plug the battery lead into the free end of the switch
and make sure that the switch is in the "off" position. Use a couple
of small tie-straps to secure the battery lead to the gearbox brace.
This will keep the wires away from any moving parts such as the
gears, throttle and brake linkages, etc.
Figure 97
!
Step 21. Slide the receiver cover (198) into place over the
rails on the top chassis brace (29), so that the top lip of the chassis
brace (29) fits up inside the receiver cover (198), and the notches
at the bottom of the receiver cover (198) fit into the holes in the
chassis (19). Be carefull to arrange the radio wires so that they fit
through the mouse-holes in the bottom of the receiver cover (198)
and are not pinched under the cover (198).
!
Step 22. Slightly bend the throttle return spring eyelet (199).
Place the throttle return spring eyelet (199) over one of the 4-40
x 3/8" cap-head screws (17), and thread the screw (17) through the
forward hole in the receiver cover (198) and into the top chassis
brace (29).
!
Step 23. Thread the other 4-40 x 3/8" cap-head screws (17)
through the rear hole in the receiver cover (198) and into the top
chassis brace (29).
17
189
198
19
42
(Continued)
Figure 96
Figure 97
17
199
29