Team Losi XXX-NT Adam Drake Edition Owner's Manual page 41

ENGINE INSTALLATION
Figure 88
!
Step 36. Cut an 11" (280mm) length of fuel tubing (176) from
the piece supplied.
!
Step 37. Cut one end of the 11" piece of tubing at a 45
as shown in Figure 88A. Install the uncut side of the tubing to the
forward fitting on the top of the fuel tank (30).
!
Step 38. Wind the tubing into two small loops and insert
them into the rectangular slot in the chassis brace (29) as shown.
Insert the cut end of the tubing into the inside (small) hole in the
tuned pipe (176). This fuel line will serve as the fuel tank pressure line.
!
Step 41. Attach one end of the fuel tubing (176) to the rear fitting
on the top of the fuel tank (30), and attach the other end to the fitting
on the carburetor. This will be your fuel line.
IMPORTANT NOTE: Make sure that the cut section of fuel
tubing is inserted all the way into the tuned pipe.
CONTINUE WITH STEP 1/ FIG 90
o
angle
176
38
(Continued)
30
Figure 88
CUT
Figure 88A
175