Figure - Team Losi XXX-NT Adam Drake Edition Owner's Manual

Figure 8

17
!
Step 17. Use the tables in Figure 7B and 7C (on the previous
page) to determine how the servo mounting posts (24) should be
!
attached to the servo (not included).
Trim any flashing from the pins on the mounting posts
so that they will seat all the way into the holes in the chassis brace
and chassis.
!
Step 18. Place a #4 washer (23) over each of the four 4-40 x
3/8" cap-head screws (17) and attach the servo posts (24) to the
servo by threading a screw (17) through the upper and lower holes
in each post (24). Do not tighten the screws (17) yet! Just snug
them up so that the posts are held in place, but can still be moved
from side to side with a little resistance. The screws (17) will be
tightened after the servo is installed so that the posts (24) have the
correct spacing.
Figure 9
!
Step 19. Install the steering post bushings (25) into the for-
ward holes in the chassis (19) as shown in Figure 9. Insert the pin
on the left servo post (24) into the hole in the servo post bushing
(25). Move the servo and posts (24) slightly until both the left and
right posts (24) are inserted in the holes in the servo post bush-
ings (25). Make sure both servo mounting posts (24) are perpendicu-
lar to the chassis, and tighten down all four servo mounting screws
!
(17).
There are two sets of servo mounting holes in the chassis.
Mounting the servo in the forward set of holes will give the best
overall performance. However, the servo may be mounted in the rear
set of holes to increase rear traction and improve handleing on very
slippery tracks. If the servo is mounted in the rear holes, you must
reverse the ball stud in the servo arm so that the ball points forward.
Figure 10
26
!
Step 20. Thread a short plastic rod end (26) onto each end of
the 4-40 x 5/8" threaded rod (27).
!
Step 21. Refer to table in Figure 7C (on the previous page) to
determine the appropriate rod length for the servo that is installed.
Tighten both sides equally until the rod is the same length as the
one shown in Figure 10A or 10B.
BAG A (Continued)
23
27
24
24
25
26
Figure 10A
4
17
Figure 8
19
Figure 9
27
Figure 10
Figure 10B
23