Team Losi XXX-NT Adam Drake Edition Owner's Manual page 48

RADIO INSTALLATION
Figure 103
!
Step 35. Install the throttle linkage Z-bend wire (191) in the
top hole of the throttle arm so that the wire is positioned on the
side of the arm toward the engine.
!
Step 36. Press the throttle servo horn (190) and throttle servo
spline insert (200) onto the output shaft of the servo, and secure it
with the screw included with your servo. Be sure the servo output
shaft is centered and the servo horn is aligned properly, as shown.
!
Step 37. Insert the end of the brake lever (102) through the
hole in the over-ride slider (195) on the brake linkage.
!
Step 38. Place a linkage collar (192) over the end of the brake
lever (102) and secure it with a 4-40 x 1/8" set screw (193).
*NOTE: The slider should fit loosely under the linkage col-
lar to prevent binding.
Figure 104
!
Step 39. Attach one end of the throttle return spring (202) to
the hole in the eyelet (199). Attach the other end of the spring
(190) to the hole toward the edge of the servo arm as shown.
!
Step 40. Remove the air filter (165) from the air filter boot
(166). Check to see that the throttle return spring is holding the
carburetor closed, and that the linkage is not pulling the carbure-
tor open.
!
Step 41. Looking through the air filter boot (166) into the
carburetor, check the opening of the small, half-moon area near the
side. This opening should be approximately 1/32" (1mm) in the fully
closed position. If it is not, refer to your engine instructions and
adjust the idle adjustment screw until the opening is
with the throttle closed.
NOTE:
Once you have completed the radio installation for a ro-
tary valve carburetor, skip ahead to page 49 and begin at
Figure 112.
Rotary Valve Carburetors
193
1/32" (1mm)
192
193
102
195
190
190
199
45
(Continued)
Figure 103
202
Figure 104
191