Team Losi XXX-NT Adam Drake Edition Owner's Manual page 46

RADIO INSTALLATION
If your engine comes equipped with a rotary valve carburetor, complete the steps in Figure 98 through Figure 104. If
your engine comes equipped with a slide valve carburetor, skip ahead to page 47 and complete the steps in Figure 105
through Figure 111.
Figure 98
!
Step 24. Slide a linkage collar (192) over the end of the throttle Z-
bend wire(191) (the shorter of the two), and position it approximately
1/4" (6mm) from the Z-bend. Secure the collar (192) with a 4-40 x 1/8"
set screw (193).
!
Step 25. Place the throttle over-ride spring (194) (longer of
the two springs) over the wire (191) and against the collar (192).
Slide a plastic over-ride slider (195) onto the wire (191), so that
the long end is towards the Z-bend.
!
Step 26. Place a brake over-ride spring (196) (black, shorter
of the two springs) over the wire (191) and against the over-ride
slider (195). Place a linkage collar (192) over the end of the wire
(191), so that the springs are somewhat compressed, and secure it
with a 4-40 x 1/8" setscrew (193). The collar (192) should be
positioned at the end of the wire (191). Final adjustments will be
made later.
Figure 99
!
Step 27. Slide a linkage collar (192) over the end of the long,
brake Z-bend wire (197), and position it aproximately 2 1/4"
(60mm) from the Z-bend. Secure the collar (192) in place with a
4-40 x 1/8" set screw (193).
!
Step 28. Slide a plastic over-ride slider (195) onto the wire
(191), so that the long end is towards the Z-bend. Place a brake
override spring (196) (black, shorter of the two springs) over the
wire (191) and against the slider (195).
!
Step 29. Slide a linkage collar (192) over the end of the wire
(191) until it just touches the spring (196). Secure it with a 4-40 x
1/8" setscrew (193). Once again, final adjustments will be made
later.
Rotary Valve Carburetors
193
193
193
191
194
193
192
195
43
(Continued)
192
195
196
192
Figure 98
196
193
192
Figure 99
193
197