Team Losi XXX-NT Adam Drake Edition Owner's Manual page 38

ENGINE INSTALLATION
Figure 80
!
Step 16. Press the paper air filter element (165) into the large
end of the air filter boot (166). Be sure that the side of the paper
element (165) with the hole in it is inserted into the boot (166).
!
Step 17. Slide the foam pre-filter (167) over the paper filter
!
(165).
Air filter oil should be applied to the foam pre-filter if you
plan to run in a dusty area. Filter oil can be purchased at any motor-
cycle shop. Do not apply filter oil to the paper filter element.
!
Step 18. Attach the air filter boot (166) to the carburetor. Secure
the boot (166) to the carburetor with a 4" tie-strap (168). Tighten the
tie-strap (168) and cut any excess material off of the tie-strap (168).
Figure 81
!
Step 19. Insert a 4-40 x 1" cap-head screw (169), from the left,
through each of the two holes in the middle of the engine.
!
Step 20. Wet your finger with water and lightly moisten the
exhaust port gasket (170) and slide it in place over the exaust port
of the engine.
!
Step 21. Position the aluminum exhaust header over the ex-
haust port on the motor and align the holes in the header flange
(171) with the screws (169). Secure the header (171) to the engine
by tightening the two screws (169).
169
166
169
3 5
(Continued)
167
165
Figure 80
171
Figure 81
170 170