Team Losi XXX-NT Adam Drake Edition Owner's Manual page 37

ENGINE INSTALLATION
Figure 78
9
*NOTE:Although not designed for a pull start engine, one can
be used but requires exhaust header #A-9321
!
Step 12. Place a ball stud washer (9) over the four 4-40 x 1/2" cap-
head screws (31). Insert a 4-40 x 1/2" cap-head screw (31) through the
four holes in the engine as illustrated.
!
Step 13. Attach the engine to the engine mounts (164) by thread-
ing the four screws (31) into the four holes shown.
*NOTE: The two engine mounts should be positioned with
!
the narrow end up as shown in Figure 78.
It's a good idea to use a thread-lock compound on the
threads of the screws in the engine mounts.
IMPORTANT NOTE: Make sure that the engine
mounts are installed correctly as indicated in Figure 78. The larger,
partially threaded holes should be positioned toward the front of
the motor, and the four screws should be installed into the smaller,
fully threaded holes.
Figure 79
!
Step 14. Install the carburetor to the engine as per the in-
structions supplied with the engine. The carburetor throttle arm
should be on the left side of the engine as shown. Check that the
arm has equal throw from center. If the arm rotates more in one
direction, loosen the nut securing the arm and re-position the
arm.
*NOTE: If your engine comes equipped with a slide valve
carburetor, the slide ball should be positioned to the left side of
the motor pointing up and forward.
!
Step 15. Tighten the carburetor locking screws or other mecha-
nism per the instructions included with your engine.
EQUAL THROW IN
BOTH DIRECTIONS
31
Figure 79A
Figure 78
3 4
(Continued)
31
164
Figure 79
9