Team Losi XXX-NT Adam Drake Edition Owner's Manual page 44

RADIO INSTALLATION
Figure 94
Rotary Valve Carburetors
23
!
Step 13. Attach the grommets (supplied with your radio sys-
tem) to the throttle servo per the radio system instructions.
!
Step 14. Route the servo lead and plug through the slot in the
bottom of the forward servo mount (188) and plug it into the slot
marked "Channel 2" or "Function 2" in the receiver.
!
Step 15. Position the throttle servo and switch mount (189)
over the throttle servo mounts (188) so that the servo output shaft
is to the rear and the switch mount (189) is to the right, as shown
in Figure 94.
!
Step 16. Place a #4 washer (23) over each of four 4-40 x 1/2"
cap-head screws (31). Thread a screw (31) through each of the
four grommets in the servo, through the slots in the switch mount
(189), and into the four holes in the top of the servo mounting
posts (188).
IMPORTANT NOTE: Do not overtighten the screws!
The purpose of having the grommets is to absorb the shock and
vibration from the gas engine. Overtightening the screws will
prohibit the grommets from working properly.
Figure 95
Slide Valve Carburetors
23
!
Step 13. Attach the grommets (supplied with your radio sys-
tem) to the throttle servo per the radio system instructions.
!
Step 14. Route the servo lead and plug through the slot in the
bottom of the rear servo mount (188) and plug it into the slot
marked "Channel 2" or "Function 2" in the receiver.
!
Step 15. Position the throttle servo and switch mount (189)
over the throttle servo mounts (188) so that the servo output
shaft is to the front and the switch mount (189) is to the right, as
shown in Figure 95.
!
Step 16. Place a #4 washer (23) over each of four 4-40 x 1/2"
cap-head screws (31). Thread a screw (31) through each of the
four grommets in the servo, through the slots in the switch mount
(189), and into the four holes in the top of the servo mounting
posts (188).
IMPORTANT NOTE: Do not overtighten the screws!
The purpose of having the grommets is to absorb the shock and
vibration from the gas engine. Overtightening the screws will
prohibit the grommets from working properly.
31
31
189
188
Figure 94
189
188
Figure 95
41
(Continued)
31
23
31
23