Radio Installation - Team Losi XXX-NT Adam Drake Edition Owner's Manual

RADIO INSTALLATION

Figure 90
!
Step 1. Cut a piece of two-sided tape (182) to the same size as
the bottom of the receiver. Remove the backing from one side of
the tape (182) and attach the tape (182) to the bottom of the re-
!
ceiver.
For best results clean the surfaces that the two-sided
tape will be attached to with a mild rubbing alcohol. This will
ensure a good, strong bond. Allow the surface to fully dry before
attaching the tape.
!
Step 2. Remove the backing from the remaining side of the
two-sided tape (182) and attach the receiver to the side of the
center chassis brace (29), between the two receiver box guide
rails as shown. The receiver should be mounted so that it is at
least 1/8" above the chassis (19) and the antenna is to the front of
the truck.
!
Step 3. Plug the steering servo into the slot marked "Channel
1" or "Function 1" on the receiver.
Figure 91
!
Step 4. Route the antenna wire up, through the antenna mount-
ing post in the center chassis brace (29).
!
Step 5. Slide the antenna wire through the antenna tube (183)
(a small drop of oil in the tube will make this easier).
!
Step 6. While pulling the wire through the antenna tube (183),
slide the antenna tube (183) down and push it firmly into the
antenna mounting post on the center chassis stiffener (29).
!
Step 7. Fold the wire over the antenna tube (183) and place
the antenna cap (184) over the tube (183) and extra wire.
*NOTE: If the antenna wire is shorter than the tube, remove
the tube and cut enough off of the tube so that the wire will ex-
tend about 3/4" past the end of the tube.
182
39
29
Figure 90
184
183
Figure 91
29