Team Losi XXX-NT Adam Drake Edition Owner's Manual page 20

Figure 41
!
Step 38. Insert the brake shaft (77) through the 3/16" x 3/8"
bearing (80) in the left gearbox half (83), aligning the teeth of the
compound gear (79) with the diff gear (64) and top gear (75) as
you do.
Figure 42
85
!
Step 39. Apply a thin coat of white assembly grease (71) along
the inside edge of the left gearbox half (83). This will help seal
the gearbox once it is assembled.
!
Step 40. Carefully place the right gearbox half (82) over the
assembled left gearbox half (83). Be sure to align each shaft into
the bearings in the right gearbox half (82).
!
Step 41. Thread the 2-56 x 5/8" cap-head screw (85) into the
!
lower, rearward hole in the gearbox housing from the right side.
Be sure you have completed Step 32, and have pre-
tapped the top three holes in the left gearbox before installing the
4-40 x 1-1/8" buttonhead screws in Step 42.
!
Step 42. Position the aluminum gearbox brace (88) on the
right gearbox half (82) as shown in Figure 42. Thread two 4-40 x
1" button-head screws (87) through the gearbox brace (88) and
into the two holes in the gearbox housing.
!
Step 43. Thread the 4-40 x 3/4" cap-head screw (86) into the
upper, middle hole in the gearbox housing from the right side.
BAG C (Continued)
87
86
83
82
86
85
87
1 7
80
77
79
Figure 41
83
Figure 42
88