Team Losi XXX-NT Adam Drake Edition Owner's Manual page 24

Figure 48
!
Step 65. Thread a 8-32 x 1/8" set screw (105) into each of the
two holes in the front of the rear pivot block (104). Thread the set
screws (104) into the holes until the ends of the set screws just
bottom out on the step indside the holes.
Figure 49
!
Step 66. Position the rear pivot block (104) on the rear of the
chassis (19) with the set screws (105) forward, and the word 'TOP"
visible at the front of the pivot block. Attach the rear pivot block
(104) to the chassis (19) with four 4-40 x 3/8" flat head screws
(20).
Figure 50
20
!
Step 67. Place the gearbox assembly onto the rear of the chas-
sis, aligning the bottom of the gearbox halves (82)(83) with the
rectangular hole in the chassis (19). Attach the gearbox assembly
to the rear of the chassis (19) with four 4-40 x 3/8" flat head
screws (20).
!
Step 68. Secure the gearbox brace (88) to the top chassis
brace (29) with two 4-40 x 3/8" cap head screws (17).
BAG C (Continued)
105
20
17
104
105
104
19
17
29
19
Figure 50
2 1
Figure 48
20
Figure 49
88
20