Table of Contents
Advertisement
To change the blotting cloth:
1.
Leave the blotting station in its default raised position. Remove the old roll of blotting
cloth and discard.
Caution:
blotting resulting in overspraying and poor quality prints. It can also
damage the print heads
2.
Remove the old cardboard core and save it for use in Step 4.
3.
Mount a new roll of blotting cloth on the lower supports. Run the cloth up the back
and over the top of the blotting station.
4.
Mount the old cardboard core on the upper supports ensuring that the pins on the
spindle engage properly with the notched core.
5.
Remove the strip of backing tape from the start of the new roll and stick the new roll
to the old core.
Note:
Make sure that you align the cloth and not the plastic start of the roll to the old core.
Also make sure the cloth is tight after you advance it.
6/2/04
Do not re-use Blotting cloth as this may cause improper
Figure 25 Mounting the Old Cardboard Core
The Blotting Station |
4-77
Advertisement
Table of Contents
Troubleshooting
