Procedure 1: Install The Rmx Manager; Procedure 2: Configure The Modem; Procedure 3: Create A Dial-Up Connection - Polycom 1500 Administrator's Manual

RealPresence Collaboration Server (RMX) 1500/1800/2000/4000 Administrator's Guide
To connect via modem to the Alternate Management Network the following procedures must be performed:
1 Procedure 1: Install the RMX Manager – the web client enables direct access to the Collaboration
Server for support purposes.
2 Procedure 2: Configure the modem – by assigning it an IP address on a specific subnet in the
Alternate Management Network.
3 Procedure 3: Create a dial-up connection – using the Windows New Connection Wizard.
4 Procedure 4: Connect to the Collaboration Server – via the RMX Manager.

Procedure 1: Install the RMX Manager

Before installing the RMX Manager, verify that you have at least 150Mb of free space on your workstation.
For more information see

Procedure 2: Configure the Modem

Configure the modem as follows:
● IP address – near
● Subnet Mask –
None of the reserved IP addresses listed in Table 5-127 on page 5-10 should be used for the IP
Address.

Procedure 3: Create a Dial-up Connection

To create a dial-up connection:
This procedure is performed once. Only the Dial field in the Connect applet (see step 10 on
button to establish a connection to LAN 3 Port via the modem.
modems.
1 In Windows, navigate via the Control Panel to the Network Connections applet and select Create a
new connection.
Polycom®, Inc.
Installing the RMX Manager Application
169.254.192.nn
255.255.240.0
.
) is modified for connection to different
Click the Dial
995