Calls To Dma Or Cucm - Polycom 1500 Administrator's Manual

RealPresence Collaboration Server (RMX) 1500/1800/2000/4000 Administrator's Guide
Procedure 2: Configuring Collaboration Server to statically route outbound SIP

calls to DMA or CUCM

1 In the IP Network Services Properties dialog box, click the SIP Servers tab.
2 In the SIP Server field, select Specify.
3 In the SIP Server Type field, select Generic.
4 Set Refresh Registration every 3600 seconds.
5 If not selected by default, change the Transport Type to TCP.
6 In the SIP Servers table:
a Enter the IP address of the DMA or CUCM in both the Server IP Address or Name and Server
Domain Name fields.
b The Port field must be set to it's default value: 5060. DMA and CUCM use this port number by
default.
7 In the Outbound Proxy Servers table:
a Enter the IP address in the Server IP Address or Name field. (The same value as entered in Step
6a.)
b The Port field must be set to it's default value: 5060.
(By default, the Outbound Proxy Server is the same as the SIP Server.)
When configuring Collaboration Server to statically route SIP calls to DMA or CUCM, it is important
to also configure the Collaboration Server's H.323 Network Service to register with CMA gatekeeper.
For more information see
Service to register with CMA
Polycom®, Inc.
Procedure 3: Configuring the Collaboration Server's H.323 Network
gatekeeper.
1101