Table of Contents
Advertisement
IDE Connector
Push Button
LED Indicators
Serial Number
Installing the StorPoint CD in a Tower
Caution!
AXIS StorPoint CD E100 User's Manual
The StorPoint CD has IDE connectors for connecting disc drives, jukeboxes,
changers and LUN expanders. Three of the four connectors are placed under the
cover.
The Push button is used for restoring the StorPoint CD parameters to the
factory default settings. See "Restoring Factory Default Settings" on page 124.
The StorPoint CD front panel indicators show the status of the unit. The
indicators have the following functions:
•
Status - Flashes during startup. The light turns solid green when the
StorPoint CD is ready for use.
•
Drive - Flashes to indicate disc access.
•
Network - Flashes to indicate the presence of network traffic.
•
Power - Remains on to indicate that power is present in the unit.
Refer to "The Front Panel Indicators" on page 122 for a list of error conditions.
The StorPoint CD serial number is found on the labels at the underside of the
server unit and at the back of the tower.
The StorPoint CD is installed in standard 5.25 inch towers.
To avoid the risk of electrical chock or other injury, disconnect power from
the tower before removing the chassis.
If not already installed in a tower when delivered, follow these steps:
1. Prepare the tower for the installation, e.g. by removing the chassis.
2. Make a note of the serial number of the StorPoint CD, or attach the enclosed
product label to the back of the tower. The serial number is found on the
underside label of the StorPoint CD and will be needed during the TCP/IP
configuration.
3. Slide the StorPoint CD into the tower.
Appendix D: Tower and Drive Installation
143
Advertisement
Table of Contents
