Introduction exacqVision Edge is a variation of the standard exacqVision Server application that operates on a compatible Axis camera. It can record video from the local camera directly to the SD memory card in the camera or remote drives. The exacqVision Client application can connect to any combination of embedded and standard servers simultaneously;...
6. Download the latest exacqVision Edge server application from https://www.exacq.com/support/downloads.html. NOTE: exacqVision Edge server software is available for both ARTPEC 3 and ARTPEC 4 processors. (ARTPEC 3 processors can host one application at a time, whereas ARTPEC 4 processors can host multiple applications simultaneously.) The download page contains a list of cameras supported by each exacqVision Edge ARTPEC version.
Page 3
Select Upload Package. It may take up to five minutes for the package to load and install. After successfully installing exacqVision Edge, exacqVision Server is displayed in the Installed Applications list. d. The License Installed column lists “no” because exacqVision software is licensed separately.
Edge can also save data to network attached storage (NAS) provided by the camera’s operating system. (An SD card must be installed even if you use NAS because critical exacqVision Edge processes run on the card.) To use NAS, make sure that: ...
Troubleshooting If you encounter a write error, complete the following steps: 1. Stop the exacqVision Edge server on the camera’s Applications page. 2. Unmount the SD card on the Storage Setup page. 3. Check the SD card. If necessary, repair and format the card.