Axis E100 User Manual page 19

BOOTP in UNIX
RARP in UNIX
AXIS StorPoint CD E100 User's Manual
Follow these steps to use BOOTP in UNIX:
1. Append the following entry to your boot table (typically
<host name>:ht=<hardware type>:vm=<vendor magic>:\
:ha=<hardware address>:ip=<IP address>:\
:sm=<subnet mask>:gw=<gateway field>
where:
= for Ethernet
ht ether
=
rfc1048
vm
= The Ethernet or node address, i.e. the StorPoint CD
ha
serial number
= The IP address of the StorPoint CD
ip
= The subnet mask
sm
= The default router address
gw
Example:
cdserv:ht=ether:vm=rfc1048:ha=00408c110086:ip=192.36.253.8
0:\
:sm=255.255.255.0:gw=192.36.253.254
2. Make sure a unique host name is mapped to the acquired IP address. Refer to
your system manuals or to the Network Administrator for instructions on how
to perform the name mapping on your particular system.
3. Start the BOOTP daemon (if not already running), typically by the command:
bootpd -a
4. Restart the StorPoint CD to download the IP address, default router address
and subnet mask.
Follow these steps to use the RARP method in UNIX:
1. Append the following line to your Ethernet address table. This is typically
performed using the command
<Ethernet address> <IP address>
Example:
00:40:8c:10:00:86 192.16.253.80
2. If you are using host names, you can map a unique host name to the acquired
IP address. Refer to your system manuals or to the Network Administrator for
instructions on how to perform the name mapping on your particular system.
3. If it is not already running, start the RARP daemon. This is typically done using
the command
rarpd -a.
4. Restart the StorPoint CD to download the IP address.
Section 2: Installing the StorPoint CD
:
/etc/ethers
):
/etc/bootptab
19