Errors When Accessing The Storpoint Cd Or An Inserted Disc - Axis E100 User Manual

Errors when Accessing the StorPoint CD or an Inserted Disc

LED Indicators
SCSI Chain
IDE Connector
IP Address
SMB Protocol
WINS Database
NDS Installation
Discs
AXIS StorPoint CD E100 User's Manual
If you get error messages when trying to access the StorPoint CD or a disc:
Consult the error table in section "Error Conditions " on page 123 to see if the
front panel indicators can help you identify the problem.
Check the SCSI chain and ensure that all the drives are switched on and that
only the last unit is terminated.
Check that no device has been configured as Slave with no Master and ensure
that all the drives are switched on.
If using TCP/IP, make sure that you have assigned a unique and valid IP address
to the StorPoint CD. If you have changed the IP address, try restarting the
StorPoint CD.
In the Microsoft & IBM networking environments, verify that the SMB
protocol is enabled.
If using WINS, check that the StorPoint CD is registered in the WINS database.
If it is, there is probably a problem with the name resolution on your network.
If you have changed any of the following parameters after installing the
StorPoint CD in the NDS tree, you might need to repeat the installation in
order to connect to the StorPoint CD:
• IP address
• Internal Net Address
• IPX Enable
• PureIP Enable
Check that the disc is not scratched or damaged in any way. Verify that the disc
works when inserted into the CD drive of a regular PC. If you are using packet
writing software or DVDs, make sure that the disc has an ISO 9660 compatible
header.
Appendix B: Troubleshooting
127