Section 2 Installing The Storpoint Cd - Axis E100 User Manual

Section 2 Installing the StorPoint CD

Note:
AXIS StorPoint CD E100 User's Manual
This section includes the setup procedures for getting your StorPoint CD up
and running:
Stage 1 - Connecting the StorPoint CD to the network
Stage 2 - Assigning an IP address
Stage 3 - Setting system parameters
You should then proceed to the relevant sections of the manual depending on
your network environment:
• "Section 3 - Microsoft & IBM Networks (SMB)"
• "Section 4 - NetWare (NCP)"
• "Section 5 - UNIX (NFS)"
• "Section 6 - Macintosh (AFP)"
• "Section 8 - Web Browser (HTTP)"
Typically, your StorPoint CD will already be installed in a CD-ROM tower


when delivered. However, if required:
• Refer to "Installing the StorPoint CD in a Tower " on page 143 on how to
install the StorPoint CD in a CD-ROM tower.
• Refer to "Connecting the Drives to the StorPoint CD " on page 145 on how
to connect CD-ROM drives to the StorPoint CD.
Section 2: Installing the StorPoint CD
11