Axis E100 User Manual page 14

Section 2: Installing the StorPoint CD
Methods for Setting
the IP Address
Note:
Web Browser
Note:
14
You can set the IP address using one of these methods, depending on your
network operating environment:
Method
Web browser *
AXIS IP Installer *
ARP *
DHCP
BOOTP
RARP *
Text editor
*) These methods operate on single network segments only, i.e. they cannot
be used over routers.
When the IP address has been successfully assigned to your StorPoint CD,


you can set the ProtectIP parameter to
malicious changing of the IP address. With this configuration, the StorPoint
CD will no longer accept a new IP address using the Web browser or ARP
method. You will find the ProtectIP parameter under the [IP] section in the
file located in the
config.ini
text editor to edit the file.
In most Windows environments, you can use a standard Web browser, e.g. Internet
Explorer or Netscape Navigator, to set the IP address.
1. Start your Web browser.
2. In the location/address field, enter the following:
<nnnnnn> are the last six digits of
the serial number, e.g. 3E5207 for
the serial number 00408C3E5207
On a Class C network, you can enter simply


<xxxxxx>_<ip4>
where are the last six digits of the StorPoint CD serial number
<xxxxxx>
and is the last group of the desired IP address.
<ip4>
Network environments
Windows 95/98 and NT
Windows 95/98 and NT, NetWare
Windows 95/98 and NT, NetWare
UNIX, OS/2
Windows NT, NetWare, UNIX,
Macintosh
UNIX
UNIX
Macintosh
in order to avoid accidental or
yes
System/ServerProperties
Follow these steps:
<ip3_ ip4> the last two groups of
the desired IP address, e.g. 253_80
for the IP address 192.16.253.80
AXIS StorPoint CD E100 User's Manual
See ...
page 14
page 15
page 16
page 17
page 18
page 19
page 19
page 20
folder. Use a