The Front Panel Indicators - Axis E100 User Manual

Appendix B: Troubleshooting

The Front Panel Indicators

Normal Conditions
122
The front panel indicators show the status of the StorPoint CD. The indicators
have the following functions:
• Status - Flashes during startup. When the StorPoint CD is ready for use, the
light turns solid green.
• SCSI/Drive - Flashes to indicate activity on the SCSI/IDE bus.
• Network - Flashes to indicate the presence of network traffic.
• Power - Indicates that power is connected to the StorPoint CD. This LED
should always remain lit and is only used to indicate power is present in the
StorPoint CD unit.
The Power LED is controlled by hardware and is always green when power is
connected. When the system starts running after startup, the Status LED turns
solid green. The SCSI/Drive and Network LEDs are turned off.
This table shows the other front panel indicators under normal conditions:
Event
Initial power to unit.
Power-up and self-test,
approx. 30 seconds.
Firmware preparation
Firmware startup.
Startup sequence OK.
Normal operation.
Writing to the SCSI/IDE bus.
Reading from the SCSI/IDE
bus.
100 Mbit packet arrived.
10 Mbit packet arrived.
Flash loading in progress.
* Flashing, short interval.
** Flashing, long interval.
Status LED SCSI/Drive LED
GREEN GREEN
GREEN GREEN
GREEN
GREEN *
GREEN
GREEN
AMBER *
GREEN *
AMBER *
AXIS StorPoint CD E100 User's Manual
Network LED
GREEN
GREEN
GREEN *
AMBER *