Quickconfig Page - Nokia M10 User Manual

Router link is used to configure some generic routing/IP address
management parameters and Ethernet interface IP parameters if
M10 is used as a router.
Bridge link is used to enable bridging and attach interfaces to the
bridge function.
ATM link is used to activate ATM channels, select payload
encapsulations to ATM and configure important ATM channel
parameters.
DSL link opens the DSL Port Configuration window which lets
you configure the DSL port settings of M10 when the unit is
working in frame (not ATM) mode on the ADSL line.
Restart M10 link restarts your M10 causing it to activate any
updated configuration information.
SNMP link is used to configure the SNMP parameters of M10.

5.1.2 QuickConfig page

The QuickConfig page lets you enter basic configuration information
for your Nokia M10. To display the QuickConfig page, click
QuickConfig on the M10 homepage.
Figure 5-2
By clicking the Internet Access-Single PPP button you can enter basic
Nokia M10 settings for an Internet access application. Normally you
only need to enter your username and password for the Internet
service.
If you have configured multiple PPP channels into use, you can
manage them through the PPP Connection Manager.
If a password has been assigned to you M10 the PAP and CHAP Setup
page will be displayed instead of the QuickConfig page.
NTC C33539002SE_A0
QuickConfig page
Copyright Nokia Telecommunications Oy
DRAFT
Management
5-3