HP 4800G Series Configuration Manual page 809

Network diagram
Figure 1-6 Network diagram for IGMP SSM mapping configuration
Device Interface
Source 1 —
Source 2 —
Switch A Vlan-int100
Vlan-int101
Vlan-int104
Switch B Vlan-int200
Vlan-int101
Vlan-int102
Configuration procedure
1) Configure IP addresses and unicast routing
Configure the IP address and subnet mask of each interface as per
configuration steps are omitted here.
Configure OSPF for interoperability among the switches. Ensure the network-layer interoperation on
the PIM-SSM network and dynamic update of routing information among the switches through a unicast
routing protocol. The detailed configuration steps are omitted here.
2) Enable IP multicast routing, enable PIM-SM on each interface, and enable IGMP and IGMP SSM
mapping on the host-side interface.
# Enable IP multicast routing on Switch D, enable PIM-SM on each interface, and enable IGMPv3 and
IGMP SSM mapping on VLAN-interface 400.
<SwitchD> system-view
[SwitchD] multicast routing-enable
[SwitchD] interface vlan-interface 400
[SwitchD-Vlan-interface400] igmp enable
[SwitchD-Vlan-interface400] igmp version 3
[SwitchD-Vlan-interface400] igmp ssm-mapping enable
[SwitchD-Vlan-interface400] pim sm
[SwitchD-Vlan-interface400] quit
[SwitchD] interface vlan-interface 103
[SwitchD-Vlan-interface103] pim sm
[SwitchD-Vlan-interface103] quit
[SwitchD] interface vlan-interface 104
IP address Device
133.133.1.1/24 Source 3
133.133.2.1/24 Receiver
133.133.1.2/24 Switch C
192.168.1.1/24
192.168.4.2/24
133.133.2.2/24 Switch D
192.168.1.2/24
192.168.2.1/24
1-22
Interface IP address
— 133.133.3.1/24
— 133.133.4.1/24
Vlan-int300 133.133.3.2/24
Vlan-int103 192.168.3.1/24
Vlan-int102 192.168.2.2/24
Vlan-int400 133.133.4.2/24
Vlan-int103 192.168.3.2/24
Vlan-int104 192.168.4.1/24
Figure 1-6. The detailed