HP 4800G Series Configuration Manual page 807

24/48 port
Table of Contents

Advertisement

Network diagram
Figure 1-5 Network diagram for basic IGMP functions configuration
Configuration procedure
1)
Configure IP addresses and unicast routing
Configure the IP address and subnet mask of each interface as per
configuration steps are omitted here.
Configure the OSPF protocol for interoperation on the PIM network. Ensure the network-layer
interoperation on the PIM network and dynamic update of routing information among the switches
through a unicast routing protocol. The detailed configuration steps are omitted here.
2)
Enable IP multicast routing, and enable PIM-DM and IGMP
# Enable IP multicast routing on Switch A, enable PIM-DM on each interface, and enable IGMP on
VLAN-interface 100.
<SwitchA> system-view
[SwitchA] multicast routing-enable
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] igmp enable
[SwitchA-Vlan-interface100] pim dm
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] pim dm
[SwitchA-Vlan-interface101] quit
# Enable IP multicast routing on Switch B, enable PIM-DM on each interface, and enable IGMP on
VLAN-interface 200.
<SwitchB> system-view
[SwitchB] multicast routing-enable
[SwitchB] interface vlan-interface 200
[SwitchB-Vlan-interface200] igmp enable
1-20
Figure
1-5. The detailed

Advertisement

Chapters

Table of Contents
loading

Table of Contents