Follow these steps to configure RIPng zero field check:
To do...
Enter system view
Enter RIPng view
Enable the zero field check
Configuring the Maximum Number of Equal Cost Routes for Load Balancing
Follow these steps to configure the maximum number of equal cost RIPng routes for load balancing:
To do...
Enter system view
Enter RIPng view
Configure the maximum
number of equal cost RIPng
routes for load balancing
Displaying and Maintaining RIPng
To do...
Display configuration
information of a RIPng process
Display routes in the RIPng
database
Display the routing information
of a specified RIPng process
Display RIPng interface
information
RIPng Configuration Example
Configure RIPng Basic Functions
Network requirements
As shown in
Figure
Switch C, which means the route will not be added to the routing table of Switch B, and Switch B will not
forward it to Switch A.
Use the command...
system-view
ripng [ process-id ]
checkzero
Use the command...
system-view
ripng [ process-id ]
maximum load-balancing
number
Use the command...
display ripng [ process-id ]
display ripng process-id database
display ripng process-id route
display ripng process-id interface
[ interface-type interface-number ]
1-4, all switches run RIPng. Configure Switch B to filter the route (3::/64) learnt from
––
––
Optional
Enabled by default
––
––
Optional
4 by default.
1-9
Remarks
Remarks
Remarks
Available in any view
Available in any view
Available in any view
Available in any view