Configuring A Static Lacp Aggregation Group - H3C S5100-SI Operation Manual

If the aggregation group you are creating already exists but contains no port, its type will change to
the type you set.
If the aggregation group you are creating already exists and contains ports, the possible type
changes may be: changing from dynamic or static to manual, and changing from dynamic to static;
and no other kinds of type change can occur.
When you change a dynamic/static group to a manual group, the system will automatically disable
LACP on the member ports. When you change a dynamic group to a static group, the system will
remain the member ports LACP-enabled.
1) When a manual or static aggregation group contains only one port, you cannot remove the port
unless you remove the whole aggregation group.

Configuring a Static LACP Aggregation Group

You can create a static LACP aggregation group, or remove an existing static LACP aggregation group
(after that, the system will re-aggregate the original member ports in the group to form one or multiple
dynamic aggregation groups.).
For a static aggregation group, a port can only be manually added/removed to/from the static
aggregation group.
When you add an LACP-enabled port to a manual aggregation group, the system will automatically
disable LACP on the port. Similarly, when you add an LACP-disabled port to a static aggregation group,
the system will automatically enable LACP on the port.
Follow these steps to configure a static LACP aggregation group:
To do...
Enter system view
Create a static aggregation
group
Enter Ethernet port view
Add the port to the aggregation
group
For a static LACP aggregation group or a manual aggregation group, you are recommended not to
cross cables between the two devices at the two ends of the aggregation group. For example, suppose
port 1 of the local device is connected to port 2 of the peer device. To avoid cross-connecting cables, do
not connect port 2 of the local device to port 1 of the peer device. Otherwise, packets may be lost.
Use the command...
system-view
link-aggregation group agg-id
mode static
interface interface-type
interface-number
port link-aggregation group
agg-id
1-7
Remarks
—
Required
—
Required