Configuring A Static Aggregation Group; Configuring A Dynamic Aggregation Group - H3C S5120-SI series Configuration Manual

CAUTION:
Removing an aggregate interface also removes the corresponding aggregation group. At the same time,
all member ports leave the aggregation group.

Configuring a static aggregation group

NOTE:
To guarantee a successful static aggregation, ensure that the ports at both ends of each link are in the
same aggregation state.
Follow these steps to configure a Layer 2 static aggregation group:
To do...
Enter system view
Create a Layer 2 aggregate
interface and enter the Layer 2
aggregate interface view
Exit to system view
Enter Layer 2 Ethernet interface
view
Assign the Ethernet interface to the
aggregation group
Assign the port an aggregation
priority

Configuring a dynamic aggregation group

NOTE:
To guarantee a successful dynamic aggregation, make sure that the peer ports of the ports aggregated at
one end are also aggregated. The two ends can automatically negotiate the aggregation state of each
member port.
Follow these steps to configure a Layer 2 dynamic aggregation group:
To do...
Enter system view
Use the command...
system-view
interface bridge-aggregation
interface-number
quit
interface interface-type
interface-number
port link-aggregation group
number
link-aggregation port-priority
port-priority
Use the command...
system-view
31
Remarks
—
Required
When you create a Layer 2
aggregate interface, the system
automatically creates a Layer 2
static aggregation group
numbered the same.
—
Required
Repeat these two steps to assign
multiple Layer 2 Ethernet interfaces
to the aggregation group.
Optional
By default, the aggregation priority
of a port is 32768.
Changing the aggregation priority
of a port may affect the
aggregation state of the ports in
the dynamic aggregation group.
Remarks
—