Setting To Output System Information To The Trap Buffer - H3C S5600 Series Operation Manual

To do...
Enable information output
for a specified switch in a
fabric
Enable system information
output to a log host
Configure the source
interface through which log
information is sent to the log
host
Configure the output rules
of system information
Set the format of the time
stamp to be sent to the log
host
After the switches form a fabric, you can use the info-center switch-on command to enable the
information output for the switches to make the log, debugging and trap information of each switch
in the fabric synchronous. Each switch sends its own information to other switches in the fabric and
receives information sent by other switches at the same time to update the information on itself. In
this way, the switch ensures the synchronization of log, debugging and trap information in the
whole fabric.
Be sure to set the correct IP address when using the info-center loghost command. A loopback IP
address will cause an error message prompting that this address is invalid.

Setting to Output System Information to the Trap Buffer

Follow these steps to set to output system information to the trap buffer:
To do...
Enter system view
Enable the information
center
Use the command...
info-center switch-on { unit
unit-id | master | all }
[ debugging | logging |
trapping ]*
info-center loghost
host-ip-addr [ channel
{ channel-number |
channel-name } | facility
local-number ]*
info-center loghost source
interface-type interface-number
info-center source
{ modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity | state
state } ]*
info-center timestamp
loghost { date | no-year-date |
none }
Use the command...
system-view
info-center enable
1-12
Remarks
Optional
By default, debugging information output is
enabled, and log and trap information output
are disabled for the master switch in a fabric.
Debugging, log and trap information output
are all disabled for other switches in the
fabric.
Required
By default, the switch does not output
information to the log host.
After you configure the switch to output
information to the log host, the switch uses
information channel 2 by default.
Optional
By default, no source interface is configured,
and the system automatically selects an
interface as the source interface.
Optional
Refer to Table 1-4 for the default output rules
of system information.
Optional
By default, the time stamp format of the
information output to the log host is date.
Remarks
—
Optional
Enabled by default.