Settings Related To Maintenance/Options; Setting The Maintenance/Inspection Cycles For The Scanner; [Maintenance And Inspection Cycle] - Fujitsu fi-6800 Operator's Manual

Chapter 8 Operational Settings

8.8 Settings Related to Maintenance/Options

Setting the Maintenance/Inspection Cycles for the
Scanner

[Maintenance and Inspection Cycle]

You can specify the cycle of regular maintenance/inspection
by a service engineer.
A message for regular maintenance appears when the time
specified here elapses after the last time regular maintenance/
inspection was performed. Messages for regular maintenance
can be checked in [Information] of the operator panel.
1
Start up the Software Operation Panel.
Refer to "8.1 Starting Up the Software Operation Panel" (page
2
From the listing on the left, click [Device Setting 2] 
[Maintenance and Inspection Cycle].
132).
3
Select whether to enable or disable [Maintenance and
Inspection Cycle].
When you enable this setting, select a cycle for maintenance/
inspection by a service engineer.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use
the Operator
Panel
Various Ways
to Scan
Daily Care
Replacing
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
180