Settings Related To Scanner Maintenance And Inspection Cycle [Maintenance And Inspection Cycle] - Fujitsu fi-7300NX Operator's Manual

Settings Related to Scanner Maintenance and Inspection Cycle
[Maintenance and Inspection Cycle]
Specify the maintenance and inspection cycle for the scanner that is performed by a service engineer.
If the specified period has passed after the last maintenance and inspection date, the touch screen displays a
notification on when you receive a [Maintenance] message.
For regular maintenance and inspection on the scanner by a service engineer, contact the distributor/dealer where
you purchased this product. Or, make an inquiry by referring to the contact information at the Contact for Inquiries
section in Safety Precautions bundled with this product.
1
Start up the Software Operation Panel.
For details, refer to
2
From the list on the left, select [Device Setting 2] → [Maintenance and Inspection Cycle].
3
Select [Enable] to receive a message on the touch screen when it gets closer to the time for
maintenance.
The factory default setting is [Disable].
4
Select the cycle to receive a message.
The factory default setting is "12 months".
Starting Up the Software Operation Panel (page
Scanner Settings (Software Operation Panel)
241).
302