Continuous Forms Eject Mode; Bar Code Print Direction - Compuprint Z03 User Manual

Continuous Forms Eject Mode

You can set Continuous Forms Eject Mode value to:
v Immediate Eject (Default)
v Delayed Eject
Selecting Delayed Eject causes the printer to wait until the end of the current page
is reached before forms are moved to the tear off position. For more information,
see "LOAD/EJECT" on page 33.
To change or check Continuous Forms Eject Mode:
1. Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
5. Press ENTER to display the current value.
6. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
7. Press ENTER.
8. Press START or RETURN to exit the Menu. See "Exiting the configuration

Bar Code Print Direction

You can set the Bar Code Print Direction to:
Unidirectional
Bidirectional (Default)
To change or check the bar code print direction, follow these steps:
1. Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
114
User's Guide
CONFIGURATION MENU
Printer Setup
Printer Setup
Forms Eject Mode
Continuous Forms Eject Mode is displayed.
An asterisk (*) will be displayed in front of the selected value.
menu" on page 39.
CONFIGURATION MENU
Printer Setup
Causes the printer to print in only one direction,
either from left to right or from right to left, for
each of the two passes of bar code printing on a
line.
Causes the printer to print as the printhead moves
in both directions. (This setting causes faster
throughput but may affect print quality. Verify that
the print quality is acceptable before running a
print job.)