Printer Compatibility 6 (Init) - Compuprint Z03 User Manual

Printer Compatibility 6 (Init)

You can set the printer to detect the Init signal and perform a partial reset when
active or to ignore the signal. You can set this value to:
Disabled
Enabled
(Default)
To change or check the Init signal, follow these steps:
10. Press START or RETURN to exit the Menu. See "Exiting the configuration
84
User's Guide
Init signal detection disabled. No action occurs when Init is activated.
Init signal detection enabled. When Init is activated, the printer performs a
partial reset.
1. Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
ASCII Configuration
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
ASCII Configuration
Printer Compatibility
5. Press ENTER.
6. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
Printer Compatibility
6 (Init)
7. Press ENTER to display the current value.
8. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
Init is displayed.
9. Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
menu" on page 39.