Perforation Skipping; Emulation Mode - Compuprint Z03 User Manual

Perforation Skipping

Use this parameter to create a bottom margin on your printed page, if the host
data stream does not create a bottom margin.
The range of values is 0 to 879 lines, at 8 lpi. The default value is 0.
To change of check perforation skipping, follow these steps:
1. Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO . The printer displays
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO . The printer displays
5. Press ENTER to display the current value.
6. Press SCROLL/MICRO or SCROLL/MICRO until the desired Perforation
7. Press ENTER.
8. Press START or RETURN to exit the Menu. See "Exiting the configuration

Emulation Mode

You can set Emulation Mode to the following values:
v 4247 (Default)
v 2381 Personal Printer
v 4202 Proprinter III XL
v Epson-FX
Note: The printer performs a partial reset to put any change to this parameter
To change or check the emulation mode, follow these steps:
1. Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
5. Press ENTER to display the current value.
6. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
CONFIGURATION MENU
ASCII Configuration
ASCII Configuration
Perforation Skipping
Skipping value is displayed.
An asterisk (*) will be displayed in front of the selected value.
menu" on page 39.
value into effect when you exit the Configuration Menu with START or
RETURN. Buffered data will be lost.
CONFIGURATION MENU
ASCII Configuration
ASCII Configuration
Emulation Mode
Emulation Mode is displayed.
Chapter 7. ASCII Configuration
75