Form Feed Mode; Controlling Tear Off Operations - Compuprint Z03 User Manual

5. Press ENTER to display the current value.
6. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
7. Press ENTER.
8. Press START or RETURN to exit the Menu. See "Exiting the configuration

Form Feed Mode

You can set Form Feed Mode to either of the following values:
v Not Active In Ready State (Default)
v Active In Ready State
Selecting Active in Ready State makes the FORM FEED key active when the
printer is ready and no job is processing, so that when pressed, a form feed will be
performed and the printer will return to the ready state.
The printer does not have to be not ready before pressing FORM FEED if you
change the value to Active in the ready state.
To change or check the form feed mode:
1. Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
5. Press ENTER to display the current value.
6. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
7. Press ENTER.
8. Press START or RETURN to exit the Menu. See "Exiting the configuration

Controlling Tear Off Operations

When a path switch is requested and the top-of-forms is at the print line, the Park
operation will begin automatically. No user intervention is required. In all other
cases, user intervention is required. The message '091 FANFOLD PARK... ' or '092
FANFOLD EJECT...' appears on the operator panel display.
110
User's Guide
Printer Setup
Continuous Forms Linking
Continuous Forms Linking is displayed.
An asterisk (*) will be displayed in front of the selected value.
menu" on page 39.
CONFIGURATION MENU
Printer Setup
Printer Setup
Form Feed Mode
form feed mode is displayed.
An asterisk (*) will be displayed in front of the selected value.
menu" on page 39.