TRENDnet User's Guide
CPE + AP Mode Configuration
When CPE+AP mode is chosen, the system can be configured as a Customer Premises
Equipment(CPE). This section provides detailed explanation for users to configure in the
CPE+AP mode with help of illustrations. In the CPE+AP mode, functions listed in the
table below are also available from the Web-based GUI interface.
OPTION
System
Wireless
Operating Mode General Setup
Advanced
WAN
Setup
Repeater AP
LAN
Setup
Functions
Wireless
DDNS
Profile
Management
Site Survey
Time Server
UPNP
SNMP
CPE+AP Mode Functions
© Copyright 2012TRENDnet. All Rights Reserved.
Advance
Utilities
Status
Profiles
System
DMZ
Settings
Overview
Firmware
Station
IP Filter
Upgrade
Statistics
Network
MAC Filter
Extra Info
Utility
Virtual Server
Reboot
QoS Plot
Parental Control
Event Log
QoS
External Network Connection
Network Requirement
It can be used as an Outdoor Customer Premises Equipment (CPE) to receive and repeat
wireless signal over last mile application, helping WISPs deliver wireless broadband
Internet service to residents and business customers. In the CPE+AP mode, TEW-
676APBO is a gateway enabled with NAT and DHCP Server functions. The wired and
wireless clients connected to TEW-676APBO are in different subnet from those
connected to Main Base Station, and, in CPE+AP mode, it accepts wireless connections
from wireless client devices.
Main
CPE+AP mode network configuration
TEW-676APBO
SSID: Repeater_Main_AP
58