Backup / Restore And Reset To Factory - TRENDnet 12dBi User Manual

TRENDnet User's Guide
SNMP ro user : Set a community string to authorize read-only access.

SNMP ro password : Set a password to authorize read-only access.

SNMP rw user : Set a community string to authorize read/write access.

SNMP rw password : Set a password to authorize read/write access.

SNMP Trap : Events such as cold start, interface up & down, and association &

disassociation will report to an assigned server.
Community : Set a community string required by the remote host computer

that will receive trap messages or notices send by the system.
IP : Enter the IP addresses of the remote hosts to receive trap messages.

Click Save button to save changes and click Reboot button to activate.
© Copyright 2012TRENDnet. All Rights Reserved.

Backup / Restore and Reset to Factory

Backup current configuration, restore prior configuration or reset back to factory default
configuration can be executed via this page.
Please click on Utilities -> Profile Setting and follow the below setting.
Save Settings to PC : Click Save button to save the current configuration to a local

disk.
Load Settings from PC : Click Browse button to locate a configuration file to restore,

and then click Upload button to upload.
Reset To Factory Default : Click Default button to reset back to the factory default

settings and expect Successful loading message. Then, click Reboot button to
activate.
TEW-676APBO
127