Site Survey; Create Wireless Profile - TRENDnet 12dBi User Manual

TRENDnet User's Guide
advanced settings and will be applied to Repeater AP.

Site Survey

Use this tool to scan and locate WISP Access Points and select one to associate with.
Please click on Wireless -> Site Survey. Below depicts an example for site survey.
ESSID : Available Extend Service Set ID of surrounding Access Points.

MAC Address : MAC addresses of surrounding Access Points.

Signal : Received signal strength of all found Access Points.

Channel : Channel numbers used by all found Access Points.

Security : Security type by all found Access Points.

Band : Wireless band used by all found Access Points.

Network Type : Network type used by all found Access Points.

Select : Click "Select" to configure settings and associate with chosen AP.


Create Wireless Profile

The administrator can configure station profiles via this page.
Please click on Wireless -> Wireless Profile and follow the below setting.
© Copyright 2012TRENDnet. All Rights Reserved.
MAC Address : The MAC address of the Wireless Station is displayed here.

Profile Name : Set different profiles for quick connection uses.

ESSID : Assign Service Set ID for the wireless system.

Lock to AP MAC : This allows the station to always maintain connection to a

particular AP with a specific MAC address. This is useful as sometimes there can be
few identically named SSID's (AP's) with different MAC addresses. With AP lock on,
the station will lock to MAC address and not roam between several Access Points
with the same ESSID.
Channel/Frequency : Select the desired channel range.

Security Type : Select the desired security type from the drop-down list; the

options are "NONE" "OPEN", "SHARED", "WPA-PSK" and "WPA2-PSK".
OPEN / SHARED : OPEN and SHARED require the user to set a WEP key to

exchange data.
TEW-676APBO
66