Table of Contents
Advertisement
TRENDnet User's Guide
Installation
1. Unscrew the black cap covering the PoE port of the TEW-676APBO
2. Install the waterproof kit and insert one end of an Ethernet cable through the kit.
3. Connect the Ethernet cable to the PoE port of the TEW-676APBO
4. Tighten and secure the seal nut of the waterproof kit.
5. Connect the other end of the Ethernet cable to the P+DATA Out port on the PoE
injector.
6. Using another Ethernet cable, connect one end to the DATA IN port of the injector.
© Copyright 2012TRENDnet. All Rights Reserved.
7. Connect the other end of the Ethernet cable to the LAN port of your network.
8. Plug the power cord into the injector. Then connect the plug into a power outlet.
Configuration
1. Open a web browser, type the IP address of the Access Point and then press Enter.
The default IP address is 192.168.10.100.
2. Enter the Username and Password and click OK. By default the Username: root and
Password: root.
3. Click the Wizard button and follow the setup wizard instructions. Click Finish to
complete installation.
TEW-676APBO
9
Advertisement
Table of Contents
