Create Virtual Ap (Vap) - TRENDnet 12dBi User Manual

TRENDnet User's Guide
Click Save button to save your changes. Click Reboot button to activate your changes.
The items in this page are for AP's RF advanced settings and will be applied to all VAPs
and WDS Links.

Create Virtual AP (VAP)

The TEW-676APBO support broadcasting multiple SSIDs, allowing the creation of Virtual
Access Points, partitioning a single physical access point into 7 logical access points, each
of which can have a different set of security and network settings. Figure 8-2 shows
multiple SSIDs with security type settings.
Multiple SSIDs with different Security Type
Virtual AP Overview
The administrator can view all of the Virtual AP's settings via this page.
Please click on Wireless -> Virtual AP Setup and the Virtual AP Overview Page appears.
© Copyright 2012TRENDnet. All Rights Reserved.
WEP
NAT
WPA-PSK/TKIP
WPA2-PSK/AES
WPA-Enterprise/TKIP
WAN WAN
VAP : Indicate the system's Virtual AP.

ESSID : Indicate the ESSID of the respective Virtual AP

MAC Address : The MAC address of the VAP Interface is displayed here. When you

enable AP and reboot system, the MAC address will display here.
Status : Indicate the Status of the respective Virtual AP. The Primary AP always on.

Security Type : Indicate an used security type of the respective Virtual AP.

MAC Filter : Indicate an used MAC filter of the respective Virtual AP.

Edit : Click Edit button to configure Virtual AP's settings, including security type and

MAC Filter.
TEW-676APBO
107