Remote Ap Status; Cpe + Ap Mode Configuration; External Network Connection; Network Requirement - TRENDnet TEW-740APBO User Manual

TRENDnet User's Guide

Remote AP status

List the current status of the remote access point.
o ESSID: SSID of remote access point
o MAC Address: Display MAC address of WDS peer.
o RSSI: Indicate the signal strength of the respective WDS links.
o TX/RX SEQ: Transmit and receive sequence.
o TX/RX Bytes: Transmit and receive bytes
o Status: Display current association status of remote access point
© Copyright 2016 TRENDnet. All Rights Reserved.

CPE + AP Mode Configuration

When CPE+AP mode is chosen, the system can be configured as a Customer Premises
Equipment (CPE). This section provides detailed explanation for users to configure in the
CPE+AP mode with help of illustrations. In the CPE+AP mode, functions listed in the
table below are also available from the Web-based GUI interface.

External Network Connection

Network Requirement

It can be used as an Outdoor Customer Premises Equipment (CPE) to receive and repeat
wireless signal over last mile application, helping WISPs deliver wireless broadband
Internet service to residents and business customers. In the CPE+AP mode, the access
point is a gateway enabled with NAT and DHCP Server functions. The wired and wireless
clients connected to the access point are in different subnet from those connected to
Main Base Station, and, in CPE+AP mode, it accepts wireless connections from wireless
client devices.
TEW-740APBO
61