Ap Mode - TRENDnet TEW734APO User Manual

TRENDnet User's Guide

AP Mode

This section outlines available management options when the device System Setting is
set to Bridge and the wireless Operation Mode is set to AP. Click Apply to save any
changes.
 Disable Wireless LAN Interface:
o Check/Off: turns off wireless networking on your router.
© Copyright 2015 TRENDnet. All Rights Reserved.
o Unchecked/On: turns on the wireless networking on your router (by default
it is enabled).
Note: It is recommended to leave the wireless setting to On unless you do not plan
on connecting any wireless computers or devices to your network.
 Operation Mode: Select the mode you want the access point to operate in.
o AP: refer to page11 for additional information.
o
Wireless Client: refer to page13 for additional information
o Bridge: refer to page 16 for additional information
o
AP Repeater: refer to page18 for additional information to operate the
device as an access point.
 Wireless Network Name (SSID): This acronym stands for Service Set Identifier
and is the name of your wireless network. It differentiates your wireless network
from others around you. By default, the access point broadcast TRENDnet734 as
the wireless network name. If you choose to change the SSID, change it to a name
that you can easily remember. You can click more to configure additional SSID.
 Broadcast SSID:
o Enable: Access point will broadcast your wireless network name (SSID),
making it easier for wireless clients to find the wireless network.
o Disable: Access point will not broadcast the wireless network name (SSID)
and wireless clients will have to manually enter the wireless network to
connect.
 802.11 Mode: If all of the wireless devices you want to connect with this Access
Point can connect in the same transmission mode, you can improve performance
slightly by choosing the appropriate mode. If you have some devices that use a
different transmission mode, choose the appropriate mode.
o 802.11A/N mixed mode - This wireless mode works in the 5GHz frequency
range and will allow both wireless A and wireless N (5GHz) client to connect
and access point.
o 802.11 A (5GHz) - This wireless mode works in the 5GHz frequency range and
will only allow the use of only wireless A client devices to connect.
 HT protect: Enable HT (High Throughput) protect to ensure HT transmission with
MAC mechanism. Under 802.11n mode, wireless client can be divided into HT STA
and Non-HT STA, among which the one with HT protect enabled gets higher
throughput.
 Channel Mode: 20MHz and 40MHz. The last one can enhance data throughput,
but it takes more bandwidth, thus it might cause potential interference.
 Channel: To manually set the channel on which the router will broadcast,
uncheck Auto Channel, then click the drop-down list and select the desired
TEW-734APO
12