TRENDnet 12dBi User Manual page 96

TRENDnet User's Guide
routing protocols such as RIP or OSPF. Static routes to specific hosts, networks or
default gateway are set up automatically according to the IP configuration of
system's interfaces. When used as a L2 device, it could switch packets and, as L3
device, it's capable of being a gateway to route packets inward and outward.
ARP table Information : Select "ARP Table Information" on the drop-down list to

display ARP table.
ARP associates each IP address to a unique hardware address (MAC) of a device. It
is important to have a unique IP address as final destination to switch packets to.
Bridge table information : Select "Bridge Table information" on the drop-down list

to display bridge table.
Bridge table will show Bridge ID and STP's Status on the each Ethernet bridge and
its attached interfaces, the Bridge Port should be attached to some interfaces. (e.g.
eth2, ra0 and apcli0).
Bridge MAC information : Select "Bridge MACs Information" on the drop-down list

to display MAC table.
This table displays local MAC addresses associated with wired or wireless interfaces,
but also remember non-local MAC addresses learned from wired or wireless
interfaces.
© Copyright 2012TRENDnet. All Rights Reserved.
Ageing timers will be reset when existing MAC addresses in table are learned again
or added when new MAC addresses are seen from wired or wireless interfaces as
well. When time runs out for a particular entry, it will be pruned from the table. In
that situation, switching packet to that particular MAC address will be discontinued.
Bridge STP Information : Select "Bridge STP Information" on the drop-down list to

display a list of bridge STP information.
TEW-676APBO
96