Access Control List; Ip Filter Setup - TRENDnet 12dBi User Manual

TRENDnet User's Guide
Profile List : The user can manage the created profiles for home, work or public

areas. Below depict an example for Profile List
Click "Edit" an exist profile on the Profile List. The field of System Configuration

and Security Policy will display profile's content. Edit profile's content and then
click "Save" button to save the profile.
Click "Delete" to remove profile.

Click and Select a profile from list, then click the "Connect" button to

connecting to the wireless network with the profile setting. After clicking
"Connect" button, the system should be jump to Station Statistic Page, you can
verify connecting status on Station Statistic Page.
Click Save button to save your changes. Click Reboot button to activate your changes

Access Control List

IP Filter Setup

Allows to create deny or allow rules to filter ingress or egress packets from specific
source and/or to destination IP address on wired (LAN) or Wireless (WAN) ports. Filter
rules could be used to filter unicast or multicast packets on different protocols as shown
in the IP Filter Setup. Important to note that IP filter rules has precedence over Virtual
server rules.
Please click on Advance -> IP Filter Setup and follow the below setting.
© Copyright 2012TRENDnet. All Rights Reserved.
Source Address/Mask : Enter desired source IP address and netmask; i.e.

192.168.2.10/32.
Source Port : Enter a port or a range of ports as start:end; i.e. port 20:80

Destination Address/Mask : Enter desired destination IP address and netmask; i.e.

192.168.1.10/32
Destination Port : Enter a port or a range of ports as start:end; i.e. port 20:80

In/Out : Applies to Ingress or egress packets

Protocol : Supports TCP, UDP or ICMP.

Listen : Click Yes radial button to match TCP packets only with the SYN flag.

Active : Deny to drop and Pass to allow per filter rules

Interface : The interface that a filter rule applies

Click "Save" button to add IP filter rule. Total of 20 rules maximum allowed in the IP
Filter List. All rules can be edited or removed from the List. Click Reboot button to
activate your changes.
When you create rules in the IP Filter List, the prior rules maintain higher priority. To
allow limited access from a subnet to a destination network manager needs to create
allow rules first and followed by deny rules. So, if you just want one IP address to access
TEW-676APBO
45