Table of Contents
Advertisement
TRENDnet User's Guide
IP Address : The IP address of the WAN port
IP Netmask : The Subnet mask of the WAN port
PPTP Server IP Address : The IP address of the PPTP server
User Name : Enter User Name for PPTP connection
Password : Enter Password for PPTP connection
Reconnect Mode :
Always on – A connection to Internet is always maintained.
•
On Demand – A connection to Internet is made as needed.
•
•
Manual – Click the "Connect" button on "WAN Information" in the
Overview page to connect to the Internet.
Idle Time : Time to last before disconnecting PPPoE session when it is
idle. Enter preferred Idle Time in minutes. Default is "0", indicates
disabled. When Idle time is disabled, the "Reconnect Mode" will turn out
"Always on"
MTU : By default, it's 1460 bytes. MTU stands for Maximum Transmission
Unit. Consult with WISP for a correct MTU setting.
MPPE Encryption : Microsoft Point-to-Point Encryption (MPPE) encrypts
data in Point-to-Point Protocol(PPP)-based dial-up connections or Point-
to-Point Tunneling Protocol (PPTP) virtual private network (VPN)
connections. 128-bit key (strong) and 40-bit key (standard) MPPE
encryption schemes are supported. MPPE provides data security for the
PPTP connection that is between the VPN client and the VPN server.
DNS : Check "No Default DNS Server" or "Specify DNS Server IP" radial button as
desired to set up system DNS.
Primary : The IP address of the primary DNS server.
© Copyright 2012TRENDnet. All Rights Reserved.
Secondary : The IP address of the secondary DNS server.
Click Save button to save your changes. Click Reboot button to activate your changes
Configure DDNS Setup
Dynamic DNS allows you to map domain name to dynamic IP address.
Please click on System -> DDNS Setup and follow the below setting.
Enabled: By default, it's "Disable". The mapping domain name won't change when
dynamic IP changes. The beauty of it is no need to remember the dynamic WAP IP
while accessing to it.
Service Provider: Select the preferred Service Provider from the drop-down list
including dyndns, dhs, ods and tzo
Hostname: Host Name that you register to Dynamic-DNS service and export.
User Name & Password: User Name and Password are used to login DDNS service.
Click Save button to save your changes. Click Reboot button to activate your changes
TEW-676APBO
60
Advertisement
Table of Contents
