TRENDnet 12dBi User Manual page 40

TRENDnet User's Guide
PPTP :
The Point-to-Point Tunneling Protocol (PPTP) mode enables the

implementation of secure multi-protocol Virtual Private Networks (VPNs)
through public networks.
IP Address : The IP address of the WAN port

IP Netmask : The Subnet mask of the WAN port

PPTP Server IP Address : The IP address of the PPTP server

User Name : Enter User Name for PPTP connection

Password : Enter Password for PPTP connection

Reconnect Mode :

Always on – A connection to Internet is always maintained.
•
On Demand – A connection to Internet is made as needed.
•
• Manual – Click the "Connect" button on "WAN Information" in the
Overview page to connect to the Internet.
Idle Time : Time to last before disconnecting PPPoE session when it is

idle. Enter preferred Idle Time in minutes. Default is "0", indicates
disabled. When Idle time is disabled, the "Reconnect Mode" will turn out
"Always on"
MTU : By default, it's 1460 bytes. MTU stands for Maximum Transmission

Unit. Consult with WISP for a correct MTU setting.
MPPE Encryption : Microsoft Point-to-Point Encryption (MPPE) encrypts

data in Point-to-Point Protocol(PPP)-based dial-up connections or Point-
to-Point Tunneling Protocol (PPTP) virtual private network (VPN)
connections. 128-bit key (strong) and 40-bit key (standard) MPPE
encryption schemes are supported. MPPE provides data security for the
PPTP connection that is between the VPN client and the VPN server.
© Copyright 2012TRENDnet. All Rights Reserved.
DNS : Check "No Default DNS Server" or "Specify DNS Server IP" radial button as

desired to set up system DNS.
Primary : The IP address of the primary DNS server.

Secondary : The IP address of the secondary DNS server.

MAC Clone : The MAC address is a 12-digit HEX code uniquely assigned to hardware

as identification. Some ISPs require you to register a MAC address in order to access
to Internet. If not, you could use default MAC or clone MAC from a PC.
Mode does not support MAC Clone function)
Keep Default MAC Address : Keep the default MAC address of WAN port on

the system.
Clone MAC Address : If you want to clone the MAC address of the PC, then

click the Clone MAC Address button. The system will automatically detect your
PC's MAC address.
Manual MAC Address : Enter the MAC address registered with your ISP.

Click Save button to save your changes. Click Reboot button to activate your changes
TEW-676APBO
(CPE+AP
40